Migration from SCI 1.x

This section describes how you migrate existing data from SCI 1.x to SCI 5.3.0.

As SCI 5.3.0 is built on a different software stack from SCI 1.x series, if there is a need to migrate existing data from SCI 1.x to SCI 5.3.0, a full migration of raw data files with complete re-aggregation of data sources is required. However, do note that data migration is not necessary for the upgrade from SCI 1.x to SCI 5.3.0. Before you start migration, ensure that you have the following pre-requisites and setup.

Note: This self-service migration feature has been tested to the best of our ability. However, we may not have covered all cases since it is highly dependent on the environment and SCI 1.x setup . If you have issues during migration, do contact Ruckus Wireless Support at https://support.ruckuswireless.com/contact-us.
Note: The migration process can take several hours per month of data, based on data volume and time span.
Note: Migration of data from SCI 1.4 is currently supported only for Smart Zone(SZ) data.