ip multicast-routing rpf-check mac-movement
-
- Last UpdatedNov 11, 2022
- 1 minute read
ip multicast-routing rpf-check mac-movement
Triggers Reverse Path Forwarding (RPF) check on MAC movement for directly connected sources and sends a MAC address movement notification to the Protocol Independent Multicast (PIM) module which results in PIM convergence.
RPF check on MAC movement for directly connected sources is not enabled.
Global configuration mode
PIM convergence on MAC movement is applicable only in a topology where the multicast source port and PIM routers are in the same Layer 2 domain.
The ip multicast-routing rpf-check mac-movement command is not supported on the RUCKUS ICX 7250 devices.
The no form of the command disables RPF check on MAC movement for directly connected sources.
The following example configures RPF check on MAC movement for directly connected sources.
device(config)# ip multicast-routing rpf-check mac-movement
Release version | Command history |
---|---|
08.0.10h | This command was introduced. |
08.0.30 | Support for the ip multicast-routing rpf-check mac-movement command was added in FastIron 08.0.30 and later releases. |