Enabling LAG Hardware Failover

LAG hardware failover reduces the time of packet loss if a LAG member is down, with minimal software intervention, using loopback on the down port. LAG hardware failover is disabled by default and is supported only on Ruckus ICX 7850 device.
Note: The LAG should be undeployed to configure the failover all command.

Enter the failover all command in the LAG configuration mode to enable LAG hardware failover. failover next command enables failover on the next port in LAG.

Complete the following steps to enable LAG hardware failover on all ports.

  1. In global configuration mode, run the lag one dynamic id 2 command to enter the LAG mode.
    device(config)# lag one dynamic id 2
  2. In LAG mode, enter the failover all command to enable LAG hardware failover on all ports.
    device(config-lag-one)# failover all

The following example enables LAG hardware failover on all ports.

device(config)# lag one dynamic id 2
device(config-lag-one)# failover all